Gems of the Hill Country



Please call for an appointment

Phone Numbers

Store Main    830-367-3368


Email Addresses



Mailing Address click on Mailing address 

P.O. Box 363  

200 Hwy 39

Ingram, Texas 78025


Login Form




In 1977, the Texas Legislature designated the Lone Star cut as the official gemstone cut of Texas. This cut was designed by Paul and Gary Worden of San Angelo, TX. It features the Lone Star, the same one on the Texas flag.



The Lone Star cut is beautiful, but it creates a deep gem, and is most suited to pendants. Since that time a number of star cuts have been developed, some with the aid of computers. One of our most popular cuts is the Lone Star brilliant cut. It has proportions similar to round diamonds and other fine gems, and is perfect for rings and earrings. Below is the citation from the state








WHEREAS, The flag of Texas, the public symbol for all to see, has a lone star as its prominent feature; and

WHEREAS, This is reflected in the State slogan "Texas - The Lone Star State" ; and

WHEREAS, A special gemstone cut known as the Lone Star Cut has been designed by two native Texans; and

WHEREAS, Any gems one may be cut in this manner, including the State Gem, the Blue Topaz; and

WHEREAS, The special characteristic of the Lone Star Cut is the appearance to the viewer when looking directly into the stone, in that it reflects the five-pointed star; now, therefore, be it

RESOLVED by the House of Representatives of the State of Texas, the Senate concurring. That the Lone Star Cut be and is hereby designated as the official State Gemstone Cut of Texas; and, now, be it further

RESOLVED, That the specifications for faceting the Lone Star Cut are for an 80 index gear and shall be as follows:



  1. Cut 10 facets at 45°. Index 4-12-20-28-36-44-52-60-68-76.
  2. Cut 5 facets at 54°, until the star is a measured 65 percent of the diameter of the stone. Index 80-16-32-48-64.
  3. Cut 10 facets at 60.7°. Index 2-14-18-30-34-46-50-62-66-78. These are to meet the points of the star exactly.
  4. Cut 5 facets at 65°. Index 8-24-40-56-72. These should also meet the points of the star exactly.
  5. Prepolish in the same order, then polish from the culet to the girdle.



  1. Cut 10 facets at 41.5°. Index 2-14-18-30-34-46-50-62-66-78. These should be cut until the girdle is of the proper thickness.
  2. Cut 5 facets at 52.1°. Index 8-24-40-56-72. Cut these until they match the corresponding facets of the pavilion in width at the girdle. This will insure the proper size for the table.
  3. Cut 5 facets at 30°. Index 80-16-32-48-64.
  4. Cut the table at 0° until the 30° facets meet at a point.
  5. Prepolish in the same order, then polish in reverse order. If desired, the table may be cut and polished last; it depends on your machine. The girdle may be polished or not, as you wish.


House Concurrent Resolution No. 97, 65th Legislature, Regular Session (1977)